Why the non-plated holes /slots in the files are produced as plated holes /slots and cause short circuit problem?

It is because these holes are on the copper plane as below picture pointed by green arrow. Then the engineer mislead them as plated .

Pls design these holes in the area which don't have copper as below picture pointed by red arrow ,then we will take them as non-plated .

Artículos relacionados

Gerber File Extention from Different Software
Generate Gerber files in Eagle
Refuse conductive adhesive technology in pcb manufacture
Notes for Gerber files Generated from Eagle 9.20
Generate Gerber file from Kicad
How to generate Gerber files from DesignSpark
How to generate Gerber files from DipTrace
How to generate Gerber file from AutoCAD
How to generate Gerber files from CircuitMaker
How to generate Gerber files from Proteus
Generate gerber file from Altium(DXP/.PCB.PCBDOC)
What a PCB Is Made Of
What is the X-out board?
How to create a Centroid File(pick place) from Eagle, Altium,Sprint Layout and ORCAD?
Generate Position File Centroid File(pick place) in Kicad
What PCB cases will be charged of extra cost?
How to generate BOM and Pick and Place File in Proteus 8.13
How to generate Gerber from Sprint Layout 6.0
Why the boards miss the cutouts/sots in the files.
Why the pads don't cover soldermask as designed on gerber files?
Why the vias produced as soldermask opening when I choose tenting vias for my order?
If my design include gold finger and I need to do bevelling, what should I do?
If my gerber file include soldermask and silkscreen layer but I choose no soldermask and no silkscreen on your website, what will you do?
What is your factory’s standard of panel by tab-route?
What is your requirements of V-cut?
How to remind PCBWay to pay attention to special notes ?
How to make my silkscreen clear and beautiful on PCB ?
What diameter of via is better to have soldermask covering ?
What is not correct for bottom text ?
Can I send the working gerber files to PCBWay for PCB production?
Why did your technical reviewer reject my order? I want it 2 layer even though there is no track on the bottom, I only need the soldering pads.
How to design the half (castellated) holes for PCB?
PCB Manufacturing Terms Glossary
Electronic Terms Glossary

Comentarios (0)

Este mensaje aquí es solo una sugerencia que complementa el contenido anterior y no para operaciones comerciales como pedidos. Si tiene alguna pregunta urgente o problemas con el pedido, comuníquese con su representante de ventas.

Sube una foto: Solo puede subir 1 archivo en total. Cada archivo no se puede exceder los 2 MB. Admite JPG, JPEG, GIF, PNG, BMP

Back

Why the non-plated holes /slots in the files are produced as plated holes /slots and cause short circuit problem?

Artículos relacionados

Mis pedidos

Mi cuenta

Balance y Cupones

Entrega

Servicio y reembolsos

Pagos

Apoyo técnico

diseño para PCB fabricación

FAQ Montaje PCB

Autoservicio