aLed Controller v2
aLed Controller is an analog leds controller for the smart home. It was designed to run with Home Assistant using ESPHome and features:
- Six analog channels. (Can control a single CCTRGB or RGBW strip, up to two RGB strips, up to three CCT strips, or up to six single color strips).
- Based on ESP32-WROOM-32.
- Runs EPSHome (or you can flash it with whatever firmware makes you happy)
- Changeable fuse
- [Optional] INA226 sensor (a current shunt and power monitor).
- [Optional] Ambient light sensor.
- [Optional] PCB temperature sensor (can be handy if you plan to run high power load).
- [Optional] SHT40 temperature and humidity sensor.
- [Optional] DS18B20 temperature sensor (cheaper, easier to get hold of, and solder compared to SHT40).
- [Optional] Outputs for up to 3 external buttons.
- [Optional] I2C bus output for plugging an external sensor.
- [Optional] Connector for ePaper display.
The controller works with 5-24v input. Positive output lines are protected by a replaceable fuse.
3D printed enclosure is available for the controller.
aLed Controller v2
*PCBWay community is a shared platform and we are not responsible for any design issues.
- Comments(0)
- Likes(2)
- Mariusz Skupiński Feb 24,2024
- Daniel K Feb 15,2024
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by dls dlsNet
- aLed Controller v2 aLed Controller is an analog leds controller for the smart home. It was designed to run with Home As...
- ICS43434 Microphone Board ICS-43434 mic board. Created to use with audio-reactive WLED. Stencil is not needed but is recommend...
- Analog LED Controller dlsHome aLED is an ESP32 based 6 channel WiFi LED controller created to integrate natively with Home...
-
IoT Indoor system with ESP32 to monitor Temperature, Humidity, Pressure, and Air Quality
98 0 0 -
Naruto Multi-color PCB printed with UV technology
78 2 1 -
-
-
-
-