Protoriam PreAmp4v3-public
Pre-Amplifier 4 is easy to build and provides Active Volume, Bass and Treble Control.
The volume control has a natural logarithmic adjustment scale, even though a linear potentiometer is used.
Usage examples are DIY Arduino Radios, Active Speakers, Instrument amplifiers or any other project where you want to add Treble, Bass and Volume control. You can also use it to extend an existing product (Active Speakers, Headphone Amps) with Treble and Bass control.
Easy to power since it has been designed to accept a wide array of voltage from single supply power supplies. If built with a TL972 Op Amp it can accept down to 2.7V. Works well with 5V USB, Powerbanks, Batteries (e.g 9V, 2xAA, CR2032, ...), or any other power source within spec of the Op Amp used.
Complete details and instructions can be found at: https://www.protoriam.com/preamp4/index.html
Protoriam PreAmp4v3-public
*PCBWay community is a shared platform and we are not responsible for any design issues.
- Comments(0)
- Likes(1)
- Engineer Jan 20,2023
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Engineer
-
-
Open Source Very Large Stick - Freejoy & MMjoy2 breakout board
593 0 0 -
RF Control training board for students based on ESP32 C3
778 0 2 -
Aquarius+ Computer, Standard PCB
1031 0 5 -
KINETIC COASTERS with a TWIST! Laser or 3D Print some DIY Magic
665 0 1 -
RPI - 8 IO PLC With ATTiny85 Watch Dog
573 0 1 -
Nintendo Famicom HVC-001 Controller Shells
683 0 1 -
COMMODORE 128 DIAGNOSTIC REV.785260 KEYBOARD DONGLE
640 0 4