Guitar hero Clone hero Mechanical LED Fret PCB
Materials You Need For Frets
- Basic Soldering Capabilities
- 24-26 AWG Stranded Wire
- 5x Kailh PG1350 (Choc V1) Switches
- 3D Printed Fret buttons for SPECIFIC GUITAR
Not all guitars share the same buttons
#8 or #10 Nylon Washers x1 FOR LP XP SG KMR
Washers not needed for WT/GH5
Materials For LED Support
- SK9822-EC20 LED's -2020 package not 5050
- Reflow Oven or Hot air station
- Low Temperature solder paste
- Stencil is Optional but nice if doing multiple boards
You can do this without a stencil but it is more complex, I have found its easiest to spread the low temp solder across the PCB pads with an chisel tip iron and then use my hot air station to put the LED in place.
WARNING
READ THE DATA SHEET FOR SK9822-EC20 for reflow temperature profile.
PERMANENT DAMAGE to the LED may be caused
What Guitars Does This PCB Support?
- Kramer
- SG
- XPlorer
- Les Paul
- World Tour
- Guitar Hero 5
This PCB comes with BOM and Centroid(Pick n Place) files to have it manufactured preassembled
Can I Use This Without LEDs?
Yes
The Nylon washer is used for the screw on side of the neck closest to the body, try to align the centered lines of the PCB to the center of your button, then snug up the screw on top of the washer without overtightening
Little to no support is offered, this PCB has been tested With LEDs
you can message me on Discord @ Snare01 but don't expect much. I'm just a hobbyist
Guitar hero Clone hero Mechanical LED Fret PCB
*PCBWay community is a shared platform and we are not responsible for any design issues.
- Comments(0)
- Likes(1)
- Engineer Mar 05,2024
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Snare 01
-
IoT Indoor system with ESP32 to monitor Temperature, Humidity, Pressure, and Air Quality
232 0 0 -
Naruto Multi-color PCB printed with UV technology
106 2 1 -
-
-
-
-