|
LED |
x 1 | |
|
CD4026BE |
x 3 | |
|
74LS00SEMICONDUCTORS
|
x 1 | |
|
CL5611AH 7 Segment Display |
x 3 | |
|
1/4W (0.25W) 3K Ω ohm Resistor |
x 25 | |
|
1/4W (0.25W) 10K Ω ohm Resistor |
x 4 | |
|
6mm Tactile Push Button Switch Micro |
x 1 |
Analog Slot Car Lap Counter (Single Lane)
This PCB will allow you to build a lap counter for your slot car track.
This was designed to be used with an arduino at 3.5v
Should work at 5v but not tested.
There is a line in for high to low break.
If your sensor is high (3 to 5 v) and drops to zero when the car breaks the sensor use this.
There is also a line in for low to high break.
If your sensor is low (zero) and jumps to High (3 to 5 v) when the car breaks the sensor use this.
input diagram (Left to right, Top to bottom)
Pin 1 Pin 2 Pin 3
vcc (3v) Data(H to L break) reset (high to reset)
Pin 4 Pin 5 Pin 6
Ground Data(L to H break) Not Used
This is for the PCB only. Components must be purchased separately.
This project is for educational purposes, no guarantee of unforeseen issues.
Analog Slot Car Lap Counter (Single Lane)
*PCBWay community is a shared platform and we are not responsible for any design issues.
- Comments(0)
- Likes(0)
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Thomas Sidener
-
IoT Indoor system with ESP32 to monitor Temperature, Humidity, Pressure, and Air Quality
232 0 0 -
Naruto Multi-color PCB printed with UV technology
106 2 1 -
-
-
-
-