1 Channel Relay Module 5V with optocoupler Support High and Low Level Trigger
Description:
1. The module uses genuine quality relay , normally open interfaces Maximum load: AC 250V/10A, DC 30V/10A;
2. Using SMD optocoupler isolation, driving ability, stable performance; trigger current 5mA;
3. The module voltage is 5Vare available;
4. The module can be set to high or low triggered by jumper;
5. Fault-tolerant design, even if the control line is broken, the relay will not operate;
6. The power indicator ( green ), relay status indicator ( red );
7. Interface design humane, all interfaces can be connected directly via terminal wiring leads, very convenient;
8. Module Size: Approx. 50mm * 26mm * 18.5mm ( L * W * H );
9. Has four mounting bolts holes, hole 3.1mm, 44.5mm * 20.5mm pitch.
Two Module Interface:
1. DC +: Positive power supply (VCC)( voltage required by the relay, 5V );
2. DC-: Negative power connection;(GND)
3. IN: Can be high or low level control relay.
Relay Outputs:
1. NO: Normally open relay interface, the relay before the vacant after the pull shorted with COM;
2. COM: Common Interface Relays;
3. NC: Normally closed relay interface relay shorted with COM ago, after the pull- vacant.
High and low trigger selection ends:
1 short jumper with LOW LOW triggered when connected ;
2 When the jumper is high with high short trigger.
- Comments(0)
You might like
-
-
-15%
PCBWay Single-Channel Relay Module with Delayed Power-off, Triggered Delay, and Cyclical Timing Circuit Switch$1.69 or 200 BeansRedeem Now -
-
Four Way Holder V3 Development Board（Compatible with Raspberry Pi/STM32)$8.99 or 1080 BeansRedeem Now -
-50%
1 Channel Relay Module 5V with optocoupler Support High and Low Level Trigger$0.99 or 120 BeansRedeem Now
-
Relay Module Interface Boards for Arduino Low Level Trigger 5V 2 Channels$2.00 or 200 BeansRedeem Now -
-
LM2596S DC-DC 3A Buck Adjustable Step-down Power Supply Converter Module$0.99 or 120 BeansRedeem Now -
-
-
-
-
USB isolator/USB to USB isolator digital signal audio power isolator ADuM3160$9.99 or 1200 BeansRedeem Now -
-
-
Dual 18650 Battery Holder V3 Development Board（Compatible with Raspberry Pi/STM32)$4.99 or 600 BeansRedeem Now -
18650 Battery Holder V3 Development Board（Compatible with Raspberry Pi/STM32)$3.99 or 480 BeansRedeem Now
