Human body infrared sensor module
Human body infrared sensor module
The module detects human activity through the principle of pyroelectricity. Once a person enters the detection area, the sensor will send a high-level signal. The Fresnel lens filter attached to the surface can improve the recognition sensitivity and reduce the effect of environmental interference. This module is often used in corridor switches, visitor notification devices, etc.
Product parameters:
VCC: power supply interface, can be connected to 3.3V, 5V
GND: Ground
OUT: Single bus digital signal output
NC: Empty interface, no need to connect
Working voltage: 3.3V/5V
Module size: 29.4mm*36mm
Sensing angle: 120°
Sensing distance: 8m
Model sensor: RDA224 digital pyroelectric sensor
Interface interface: interface interface, DuPont line interface, PH2.0 cable interface
Connection:
1. Alligator clip connection
(Recommended scenario: use of micro:bit motherboard or micro:bit expansion board)
2. Dupont line connection
(Recommended scenario: common connection methods such as Raspberry Pi and Arduino)
3. PH2.0 cable connection
(Recommended scenarios: common connection methods such as robot kits, sensor expansion boards, etc.)
- Comments(0)
You might like
-
-
PCBWay MPU-6050 Module 6DOF Three-Axis Accelerometer Gyroscope Module GY-521$1.99 or 240 BeansRedeem Now
-
-
-
-
-
-
-
-
Sound sensor module (voice control switch, audio detection/analog + digital)$6.00 or 720 BeansRedeem Now
-
-
-
-
-
-
-
Capacitive Soil Moisture Sensor Not Easy To Corrode Wide Voltage Module$4.00 or 400 BeansRedeem Now
-