this is a regular arduino board which all u need to do is solder the components and use a (FT232RL) or (CH340) USB to TTL converter to upload a code. If u dont have this converter it's ok. u can simply follow the procedures below.


NOTE : If your using the (FT232RL) or (CH340) convertor , pls make sure you fix a 0.1uf(104) capacitor between the RST pin and DTR pin of the arduino.



you will need: ATmega328p(with bootloader),10k rsistor,220ohm resistor,led,16MHz crystal, 4 pin pushbutton switch, (FT232RL) USB to TTL conveter, LM7805, LD1117, female pin headers, alotof lead.



In case u don't have a (FT232RL) or (CH340) USB to TTL conveter simply follow these steps,


  • first take a regular arduino UNO board and REMOVE it's micro controller(ATmega328p).

  • then connect the ARDUINO's RST, TX, RX, VCC, GND pin to ur pcb.

  • after making the connections, simply go to the arduino IDE and upload a sketch.

  • for more info about the connections click the link below.


arduino upload code using another arduino


please vote my project :)

Jan 10,2019
721 viewsReport item
  • Comments(0)
  • Likes(3)
You can only upload 1 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
    View More
    VOTING 1 votes
    • u****lid from SRI LANKA
      i love PCBs
      • 10
        design
      • 10
        usability
      • 10
        creativity
      • 10
        content
      10.00
    View More