My ESP32-WROMM-32 doesnt enter into boot mode

Engineer asked Dec 05,2022
0

Product: ESP32-WROOM-32.
Application: Thermocirculator applied to the Sous Vide culinary technique.
Controls: DC motor, heater, OLED display, cooler.
Receives data from: Temperature sensor, water level sensor, 2 push buttons.

Problem: I followed the component's datasheet schematic, but i have not been able to send the firmware to the microcontroller. I have not been able to turn it into it's boot mode even though when I press the button and the IO0 receives a low logic state.


Note: I followed the component's datasheet schematic, but i have not been able to send the firmware to the microcontroller. I have not been able to turn it into it's boot mode even though when I press the button and the IO0 receives a low logic state.



  • Your Answer(3)
You can only upload 1 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000
    Browse other questions tagged or ask your own question.